These watches are really slick. They have a number of features not foundon most analog watches. Some of these features you may never use.That’s OK!Tur
• When the measurement is stopped or split time is measured, the 1/100 secondand the 1/10 second hands indicate the 1/100 and 1/10 seconds measured• W
In TIME mode (super) or DEMO mode (regular) youcan demonstrate the movement of the hands.1. Keep A and B pressed simultaneously forapproximately 2 sec
In TIMER mode you can set the timerto count down from up to 60 minutes.While in TIMER mode, the hands movecounterclockwise.The timer continues to coun
In SET mode you can set the alarm.When the mode indicator is set to SET, the hour, minuteand 24-hour hands move to indicate the alarm time.Alarm
If at 12:00 the hands do not line up exactly as theyshould, reset them to the 12 o’clock position inCHRO mode.This procedure must be followed after ch
If at 12:00 the hands do not line up exactly as theyshould reset them to the 12 o’clock position inDEMO mode.1. Pull the crown (C) out2. Press A repea
Super RegularMODE LIMITSChronograph 23 hours 59’59”59 59’59”59WATER RESISTANCE 10 ATM 10 ATMTRIAX MATERIALSCrystal Mineral Glass Mineral GlassCase St
ENG3Watch Diagrams . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4TIME • TIME . . . . . . . . . . . . . . . . . . . . . . . . . .
ARMORED TRIAX SUPER Watch Diagram4ENGA - START/STOPB - LAP/RESETC - SET MODE(Crown)D - Hour HandE - Minute HandF - 1/100 Second HandG - Second HandH -
ARMORED TRIAX REGULAR Watch DiagramENG5A - START/STOPB - LAP/RESETC - SET MODE(Crown)
In TIME or TIME mode you can set the time.If at any point the hands become out of sync,reset them to the 12 o’clock position.See Adjusting the Hand Po
In CALEN mode the month and date are indicated.How to Read the Calendar• The month is indicated by the hour andminute hands• The date is indicated by
In CHRO mode you can measure up to 23hours 59 minutes and 59 seconds.In STOP W. mode you can measure up to60 minutes in 0.2 second intervals.Lap time
In CHRO and CHRO .01 modes, the hands indicatedifferent time units depending on the mode inuse and the elapsed time.How to Read the Hands• After 1 hou
In CHRO .01 mode you can measure in1/100 second increments.Split time measurement is also possible.The elapsed 1/100 seconds are indicatedby the tail
Comments to this Manuals